Installation Instructions - ADJ MDF2-9SYS User Manual

I N S T A L L A T I O N I N S T R U C T I O N S
PANEL SET UP INSTRUCTIONS
1. Start by setting up the Panel Power Ramps. Connect all Panel Power Ramps to each other by
stringing together both the DMX connections and the power cable connections.
NOTE: One Panel Power Ramp is required for each column of panels.
2. Slot the feet of the Panel Power Ramps into the Panel Floor Brackets.
This will hold the Panel Power Ramps together.
NOTE: Be sure to leave Panel Floor Bracket slots open when installing the Panel Floor
Brackets at both ends of the row of Panel Power Ramps. These slots will be used later to
install the Panel Dummy Ramps.
12