Table of Contents
Advertisement
I N S T A L L A T I O N I N S T R U C T I O N S
PANEL SET UP INSTRUCTIONS
7. If desired, use the Menu Display screen to configure the settings of the individual panel.
(see System Menu section on page 20).
NOTE: Due to panel orientation requirements, the Menu Display screen may not be
accessible after additional panels have been installed.
8. Each subsequent panel in the same column should attach to the Menu Display screen side of
the panel preceding it and should be oriented so that the arrows on each side of the panel
point directly away from the power supply ramps.
The installation procedure for each subsequent panel will follow steps 4 to 7 and should
proceed in the direction of power/data flow. When starting a new column, remember to begin
with the panel closest to the power supply ramp and proceed in the direction of power/data
flow. See the diagram above for reference. Continue in this manner until all panels in your
system have been installed.
CAUTION: DO NOT SLIDE PANELS INTO POSITION! THIS MAY RESULT IN EXTENSIVE
DAMAGE TO PANEL ELECTRONICS! INSTEAD, PANEL SHOULD BE LIFTED AT THE
EDGES AND DROPPED VERTICALLY INTO POSITION.
16
Advertisement
Table of Contents
