Installation Instructions - ADJ VIZI CMY300 User Manual

I N S TA L L AT I O N I N S T R U C T I O N S
DO NOT INSTALL THE FIXTURE IF YOU ARE NOT QUALIFIED TO DO SO!
Fixture MUST be installed following all local, national, and country commercial electrical and construction
codes and regulations.
Before rigging/mounting a single fixture to any metal truss/structure or placing the fixture(s) on any
surface, a professional equipment installer MUST be consulted to determine if the metal truss/structure
or surface is properly certified to safely hold the combined weight of the fixture(s), clamps, cables, and
accessories.
Ambient operating temperature range is 32°F. (0°C) to 104°F. (40°C).
Fixture(s) should be installed in areas outside walking paths, seating areas, or away from areas where
unauthorized personnel might reach the fixture by hand.
NEVER stand directly below the fixture(s) when rigging, removing or servicing.
Overhead fixture installation must always be secured with a secondary safety attachment, such as an
appropriately rated safety cable that can hold 10 times the weight of the fixture. Allow approximately 15
minutes for the fixture to cool down before serving.
CLAMP INSTALLATION
Screw one clamp via a M12 screw and nut into each Omega
Bracket. Insert the quick-lock fasteners of the Omega
Bracket into the respective holes of the fixture base.
NOTE: The clamp must be attached to the Omega
Bracket before attaching the bracket to the fixture.
Tighten the quick-lock fasteners fully clockwise. Pull
the safety-cable through the opening located on the
bottom of the unit and over the trussing system or a
safe fixation spot. Insert the end in the carabiner, and
tighten the safety screw.
11