Table of Contents
Advertisement
I N S T A L L A T I O N I N S T R U C T I O N S
PANEL SET UP INSTRUCTIONS
5. Connect a panel to any of the power supply ramps using the docking magnets, making sure
that each foot on the panel slots into the holes in the Connection Brackets. Adjust the position
of the Connection Brackets as needed to align them with the panel feet. The panel itself should
be oriented so that the arrows on each side of the panel are pointing directly away from the
power supply ramp.
NOTE: If placed in any other orientation, the panel will NOT receive power or DMX signal.
Sample diagrams are shown on page 18.
CAUTION: DO NOT SLIDE PANELS INTO POSITION! THIS MAY RESULT IN EXTENSIVE
DAMAGE TO PANEL ELECTRONICS! INSTEAD, PANEL SHOULD BE LIFTED AT THE
EDGES AND DROPPED VERTICALLY INTO POSITION.
6. Stand on the panel to check that it is stable and does not wobble. If wobbling is detected, the
panel feet may be adjusted to compensate. To adjust the feet, simply twist to alter the height.
NOTE: Excessive wobbling may lead to poor power or DMX signal connection to the panel.
15
Advertisement
Table of Contents
