Installation Guidelines - ADJ ELECTRAPIX PAR 7 User Manual

I N S T A L L A T I O N G U I D E L I N E S
DO NOT INSTALL THE FIXTURE IF YOU ARE NOT QUALIFIED TO DO SO!
Fixture MUST be installed following all local, national, and country commercial electrical and construc-
tion codes and regulations.
When installing the unit, the trussing or area of installation must be able to hold 10 times the weight of
the unit and any attached accessories without any deformation. The unit must be secured with a sec-
ondary safety attachment, e.g. an appropriately-rated safety cable.
Before rigging/mounting a single fixture to any metal truss/structure or placing the fixture(s) on any
surface, a professional equipment installer MUST be consulted to determine if the metal truss/structure
or surface is properly certified to safely hold the combined weight of the fixture(s), clamps, cables, and
accessories.
Ambient operating temperature range is -4°F to 113°F (-20°C to 45°C). Do not operate this device
when ambient temperature falls outside this range!
Fixture(s) should be installed away from walking paths, seating areas, or areas where unauthorized
personnel might reach the fixture by hand.
NEVER stand directly below the fixture(s) when rigging, removing, or servicing.
Overhead fixture installation must always be secured with a secondary safety attachment, such as an
appropriately rated safety cable that can hold 10 times the weight of the fixture.
Overhead mounting requires extensive experience, including calculating working load limits, knowl-
edge of installation material being used, and perodic safety inspection of all installation material as
well as the unit itself. If you lack these qualifications, do not attempt the installation yourself.
The installation should be checked by a skilled person once a year.
Please note that this device features an alarm system that, if set and activated, will be trig-
gered by any movement of the device, including knocking over the device. The alarm will
sound and the device will strobe red for the amount of time that was set in the "Alarm Time"
setting, but will automatically stop when the device is returned to its place. Please be aware
of this feature in the event that you decide to re-locate or re-position the device after the initial
setup!
12