Table of Contents
Advertisement
S A F E T Y I N S T R U C T I O N S A N D G U I D E L I N E S
DO NOT position Panels or Power Supplies close to any FLAMMABLE MATERIALS while operating.
DO NOT attempt installation and/or operation without knowledge of how to do so.
DO NOT permit operation by persons who are not qualified to operate these types of devices.
DO NOT shake Panels or Power Supplies, avoid brute force when installing and/or operating.
DO NOT apply masking or stage tape to panel surface to prevent sticky adhesive residue build-up.
DO NOT operate Panels if any of the Power Ramp or Power Supply cords have become frayed,
crimped and/or damaged. Replace any damaged Power Ramps or Power Cords as needed.
DO NOT remove or break off the ground plug from the Power Supply power cords.
DO NOT remove or disassemble Panels, there are NO user serviceable parts inside.
ALWAYS disconnect Power Supply from main power source before performing any cleaning.
ALWAYS be sure to install Panels and Power Supplies in an area that will allow proper ventilation.
ONLY use hardware and accessories which are listed in this guide.
ALWAYS safely route and secure all Power Supply power cords to prevent a tripping hazard.
ALWAYS disconnect all Power Supplies during long periods of non-use.
ONLY use the original packaging and materials to transport these devices for service.
Panels and Power Supplies should be serviced by qualified service personnel when:
• Power cords and/or plugs have become damaged
• Heavy objects have fallen onto them
• Exposed to rain and/or dampness/moisture
• They do not operate normally or exhibit a marked change in performance.
7
Advertisement
Table of Contents
