Installation - ADJ PIXIE CURVE 60 User Manual

I N S T A L L A T I O N
FLAMMABLE MATERIAL WARNING!
Keep drive a minimum of 5.0 feet (1.5m) away from flammable material and/or pyrotechnics.
ELECTRICAL CONNECTIONS
A qualified electrician should be used for all electrical connections and/or installations.
DO NOT INSTALL THE DEVICE IF YOU ARE NOT QUALIFIED TO DO SO!
The device MUST be installed following all local, national, and country commercial electrical and con-
struction codes and regulations.
Maximum ambient operating temperature range is -4°F to 113°F (-20°C to 45°C). Do not operate this
device when ambient temperature falls outside this range.
Before rigging or mounting a single fixture or multiple interconnected fixtures for custom matrix de-
signs to any metal truss or structure or placing the fixture(s) on any surface, a professional equip-
ment installer MUST be consulted to determine whether the metal truss, structure, or surface is prop-
erly certified to safely support the combined weight of the fixture(s), clamps, cables, and any other
accessories.
Fixture(s) should be installed in areas outside walking paths, seating areas, or away from areas
where unauthorized personnel might be able to reach the device by hand.
NEVER stand directly below the fixture(s) when rigging, removing, or servicing. Overhead fixture in-
stallation must always be secured with a secondary safety attachment, such as an appropriately rated
safety cable (not included) that meets all local, national, and country codes and regulations. Allow
approximately 15 minutes for the fixture to cool down before servicing.
SOCKET PIN CONFIGURATION
This device features two (2) power/data ports, which may be used to connect the device to other
lighting fixtures. The pins for each output socket are configured as shown in the image below. Please
consult a qualified electrician for all electrical connections and/or installations.
Pin 1: Power (+)
Pin 2: Data
Pin 3: CLK (clock pin)
Pin 4: Power (-)
9