Transmit Request Frame - 0X10 - Digi XBee 868LP User Manual

Operate in API mode

Transmit Request frame - 0x10

Description
This frame causes the device to send payload data as an RF packet to a specific destination.
For broadcast transmissions, set the 64-bit destination address to 0x000000000000FFFF for
n
all devices.
For unicast transmissions, set the 64 bit address field to the address of the desired destination
n
node.
Set the reserved field to 0xFFFE.
n
Format
The following table provides the contents of the frame. For details on the frame structure, see
frame format.
Frame data
fields
Frame type
Frame ID
64-bit
destination
address
Reserved
Broadcast
radius
Transmit
options
RF data
Transmit Options bit field
Bit field:
Bit Meaning
0 Disable ACK
1 Disable RD
2 NACK
XBee 868LP RF Modules User Guide
Offset Description
3 0x10
Identifies the data frame for the host to correlate with a subsequent ACK.
4
If set to 0, the device does not send a response.
MSB first, LSB last. Set to the 64-bit address of the destination device.
5-12
Broadcast = 0x000000000000FFFF
13-14 Set to 0xFFFE.
15 Sets the maximum number of hops a broadcast transmission can occur. If
set to 0, the broadcast radius is set to the maximum hops value.
See the following Transmit Options table.
16
Up to NP bytes per packet. Sent to the destination device.
17-n
Description
Disable acknowledgments on all unicasts.
Disable Route Discovery.
Enable unicast NACK messages.
Frame data
API
175