Section
2.2
Service Training
Page
4
2.2.2
DRIVE AXLE DISASSEMBLY AND ASSEMBLY
Disassembly:
- Remove the motor brush cover on each traction motor.
- Remove the fan along with the air duct.
- Remove the two lower socket head screws (3).
- Remove socket head screws (8).
- Take out the brake shoes (4) and (5) with bushings (6) and (7).
- Separate the two drive halves (1) and (2).
Assembly:
- Join the two drive halves (1) and (2) and bring them into alignment.
- Insert the brake shoes (4) and (5) with bushings (6) and (7).
- Screw in socket head screws (8).
- Screw in the lower socket head screws (3).
- Torque socket head screws (3) and (8) to 540 Nm.
- Install the fan along with the air duct.
- Fasten the motor brush cover on each traction motor.