Drive Axle Installation - Linde E25 Service Training

Section 2.2
Service Training
Page 10
2.2.5

DRIVE AXLE INSTALLATION

- Move the pre-assembled drive axle with a pallet truck into the truck.
- Raise the axle until the bearing plate socket head screws can be inserted.
- Tighten 8 socket head screws each on the bearing plates and torque them to 600 Nm.
- Mount the lever (8) and the connecting rod (11) and fasten them to the bearing plates with screw (7).
- Check the brake levers for ease of movement.
- Insert the bolt with cotter (9) on the two brake shoes (5) and (6).
- Hook the parking brake cable (4) to the brake shoes (5) and (6).
- Adjust the parking brake cable (4) with the nut (2) and tighten the locknut (3).
- Mount the hose on the air duct.
- Connect the cable connector to the fan.
- Connect the cable connector to the speed sensor at the left-hand traction motor.
- Connect the traction motor cables.
- Check the oil level in the wheel drive gearbox, adding SAE 85W / 90 transmission oil, if needed.
- Mount the wheels and torque the wheel bolts to 460 Nm.