Linde E25 Service Training page 155

Service Training
Installation:
- Carefully position the distance sensor (1) on the sleeve retainer (3) or spring (7), being sure that the number
and location of the shims is correct. Retain the original connector position.
- Screw in and hand tighten the two socket head screws (4) and lock washers (5).
- Install the plug on the distance sensor.
- Remove the support at the control valve and lower the control valve.
The control of the distance sensor output signal is described in the section 2.6 on the electrical system.
Section 2.7
Page 5