Linde E25 Service Training page 154

Section 2.7
Page 4
2.7.4.3 Distance sensor
A replaceable distance sensor is installed on each hydraulic segment of the control valve.
Distance sensor removal
- Jack up and secure the truck.
- Tilt the cabin back to the 2nd detent.
- Disconnect the battery plug.
- Pull the control valve assembly approx. 5 - 6 cm out of the mounting with a pry bar and support the valve.
- Disconnect the connector on the distance sensor (1).
- Remove the two socket head screws (4) and lock washer (5).
- Carefully pull the distance sensor down and out of the sleeve retainer (3), taking care not to lose any shims
(6).
NOTE: The shims are necessary for the mechanical adjustment of the distance sensor. Depending on
the version of the control valve, one or more shims may be installed. These shims must be re-
installed during the installation of the distance sensor.
1 Distance sensor
2 Sleeve
3 Sleeve retainer
4 Socket head screw
5 Lock washer
6 Shims
7 Spring
Service Training