Increasing Or Reducing The Heat Setting Of A Cooking Zone; Switching Off Individual Cooking Zones - Hanseatic HHI6417SM User Manual

Page GB-12 Cooking zones and sensors
If you do not press a sensor or do not
place suitable cookware on the cook-
ing zone within one minute of switching the
hob on, the hob will switch off automatically.
You cannot activate the '+'- and '-'
sensors with normally illuminated indi-
cators before you have selected a cooking
zone.
If there is no pot, or no suitable pot,
placed on the selected cooking zone,
the ' ' indicator will appear beside the cor-
responding sensor after approximately two
seconds. As soon as you place a suitable
pot on the cooking zone, the selected heat
setting will again be displayed.
In rare cases, this indicator may also appear
when there is a suitable pot. After a few sec-
onds, however, the selected heat setting will
be displayed again.
Increasing or reducing the
heat setting of a cooking zone
Even if the cooking process has already be-
gun, you can increase or decrease the heat
setting of a cooking zone.
1. Press the sensor for the required cooking
zone.
The indicator beside the cooking zone will
blink.
2. Press the '+' sensor (10) (multiple times
in a row if necessary) or press and hold it
down with your finger longer to increase
the heat setting of the cooking zone.
Press the '-' sensor (11) (multiple times in a
row if necessary) or press and hold it down
with your finger longer to reduce the heat
setting of the cooking zone.
After a few seconds, the indicator for the
selected cooking zone will be normally lit
and the new heat setting will have been
selected.
When the ' ' indicator and not the heat set-
ting is blinking in the display, this may have
the following causes:
– The cookware is not placed on the cor-
rect cooking zone.
– The cookware being used is not suitable
for induction hobs.
– The cookware is too small or is not cen-
tred on the cooking zone.
As long as there is no suitable cookware on
the cooking zone that is switched on, no heat-
ing will occur.
Switching off individual
cooking zones
1. Use the sensor field (5) to select the ac-
tive cooking zone.
2. Press the '-' sensor (11) (multiple times
in a row if necessary) or simultaneously
press the '+' and '-' sensors until the heat
setting '0' indicator is displayed.
CAUTION
Risk of burns!
Only switch a cooking zone off using the
■
sensors, and never by removing the pot
from the cooking zone. If you remove
the pot from the cooking zone, the zone
will be reactivated as soon as a pot or
other object made of ferromagnetic ma-
terial is placed in it.