Child Safety - Hanseatic HHI6417SM User Manual

If other cooking zones are likewise switched
on, these will remain active.
7. To shut off a signal tone early, press ei-
ther the '+' sensor button or the '-' sensor
button.
The maximum timer setting is 99 min-
utes. You can switch off all cooking
zones using a timer.
A red dot will light up continuously be-
side the heat setting display for the
selected cooking zone to indicate that the
timer for this cooking zone is active.
Change the time in the cooking time
limit
You can change a shut-off time that has al-
ready been set at any time.
1. Press the sensor for the cooking zone, for
which the timer has been set.
A dot will light up beside the heat setting
display for the cooking zone.
The heat setting display for the selected
cooking zone will blink.
2. Press the timer sensor (7).
The remaining number of minutes until
shut-down will flash for a few seconds. The
setting can be changed while this indica-
tor is flashing. Afterwards, the indicator will
again be lit normally.
3. To set the indicator to '0' and switch off
the timer, simultaneously press the '+'
sensor (10) and the '-' sensor (11).
When the shut-down function is activated,
a red dot will light up continuously next to
the heat setting display for the selected
cooking zone.
Cooking zones and sensors

Child safety

Your hob is equipped with a child safety de-
vice, which must be deactivated prior to using
the hob or changing the settings. This pre-
vents unauthorized switching on.
Activating the child safety device
1. Switch the hob on using the on/off sen-
sor (8).
2. Set the cooking zones and, if applicable,
the timer, as desired.
3. Press the child safety sensor (9).
All sensors are now deactivated except the
on/off sensor. This is indicated by a blinking
'LO' beside the timer sensor (7).
When the child safety feature is
switched on, all sensors are deactivated
except the on/off sensor. The hob can be
switched on even if the child safety device
is activated. You must, however, deactivate
the child safety device before the next use.
Deactivating the child safety device
1. Ensure that the hob is switched on.
The 'LO' indicator will blink beside the timer
sensor (7).
2. Press the child protection sensor (9) for
three seconds.
The 'LO' sensor will go out and the '--' indi-
cator will appear beside the time sensor.
Now you will again be able to use all of the
sensors on the hob.
Page GB-15
LO