Assa Abloy Sargent v.S1 Profile Installation Instructions Manual page 7

Profile Series v.S1 PoE Cylindrical Lock
Door Position Switch
D
1. Prep door according to proper template (Fig. D1).
2. Insert connector end of DPS through the raceway on the latch
edge of the door (Fig. D2).
Note: Only use collar when installing in a metal door.
3. To insert DPS, push wires through raceway toward lock prep.
4. Push DPS firmly into place by hand.
IMPORTANT
: DO NOT TAP SWITCH WITH ANY TOOL.
5. To connect DPS to lock controller per diagram, refer to the wiring
instruction sections in the Installation Instructions section.
Raceway
Fig...D2
Inside.of.Door
Collar is used only
with metal doors.
Dim 1
Dim 2
(See template)
Door Position
Switch (DPS)
Horizontal
of Strike
Wood Frame Metal Frame
Dim 1
3/8" 3/4"
Frame
Door Position
Switch Hole
Vertical
of Strike
Strike for Cylindrical Lock
Fig...D1
A7763B 7