Assa Abloy Sargent v.S1 Profile Installation Instructions Manual page 13

Profile Series v.S1 PoE Cylindrical Lock
Step #5 – Lock Adjustment
A..Lock.Preset:
• Lock body holes: 12 and 6 o'clock (Fig. 5A).
• Door thickness: 1-3/4" thick. Refer to adjustments
below for other door conditions (Fig. 5B Detail).
B..Through-Bolt.and.Door.Thickness.Adjustment:
1. Remove outside lever, scalp, and spacer bushing (Fig. 5A).
2. Rotate mounting plate to either align with through-bolt holes
in door, or adjust for proper door thickness (Fig. 5A and 5B).
Refer to markings on through-bolt post.
3. Re-install spacer bushing to align with back of lever,
scalp, and lever.
Step #6 – Outside Lever
A..How.To.Remove.Outside.Lever
1. Insert key, rotate 45° clockwise and hold.
2. Depress lever retainer with push pin tool (provided).
B..How.To.Change.Cylinder.(if.Necessary)
1. With outside lever in hand, use standard
pliers to pull out cylinder retainer.
2. Remove key and cylinder from lever.
3. Insert new cylinder.
4. Secure by pressing cylinder retainer flush
with the lever.
1-3/4" Thick Doors
2" Thick Doors
Fig..5B.Detail
Washers required for
30- prefix (10 Line Lever)
to accept Schlage cylinder
(no cylinder provided)
Through-bolt Hole
Fig..5A
Push Pin Tool Fig...6A
Cylinder
Retainer
Cylinder
Spacer
Cylinder
Fig..6B
Outside.of.Door
Spacer Bushing
Rotate to match
through-bolt
holes in door
˚
Key
Outside
Lever
A7763B 13