Assa Abloy Sargent v.S1 Profile Installation Instructions Manual page 15

Profile Series v.S1 PoE Cylindrical Lock
Step #8 – Install Gasket and Outside Escutcheon
For exterior applications, use weatherseal gasket between escutcheon and outside door
surface.
To apply weatherseal gasket:
1. Carefully remove the backing from the gasket (Fig. 8A).
2A. For fire rated doors:
outside of door through weather seal gasket and fire stop plate (Fig. 8A).
2B. For non-fire rated doors
and ground wire from outside of door through weather seal gasket (if used) and
weather conduit (if used; not shown).
Note: Install ribbon cable with cable exiting down.
3. Apply gasket to escutcheon:
a. Starting in one place, press the adhesive side
of the gasket firmly against the escutcheon.
b. Work around the escutcheon, pressing the
sticky side of the gasket firmly against the
escutcheon edge.
c. The gasket should be aligned so that all edges
of the escutcheon are covered.
4. Place the outside escutcheon against, while
directing mounting posts through the door.
Feed ribbon cable with connector and ground wire from
:.
Feed ribbon cable with connector
Fig...8A
Gasket
Keypad
Ribbon
Cable
Antenna
(iCLASS)
Only
Ground
Wire
(E1)
Cylinder spacer
Outside.of.Door
A7763B 15