Assa Abloy Sargent v.S1 Profile Installation Instructions Manual page 17

Profile Series v.S1 PoE Cylindrical Lock
Step #11 – Ciruit Board Wiring
Before installing escutcheon, route raceway cables and ground attach to
front of circuit board.
Turn the controller assembly over:
1. Route the raceway connectors over the top of the controller assembly
and plug into the front of the circuit board (side that faces out when
mounted (J7, J4; Fig. 12A).
2. Route the 2 ground ring terminals, one from the lock and the other
from the hinge wiring, over the top of the controller assembly and con-
nect both to the top escutcheon screw.
Note: Connectors go on only one way.
Do not offset connectors and make sure they are completely seated.
Step #12 – Install Inside Escutcheon
1. Gently fold the excess ribbon connector and ground wire into the
top hole, JST connectors and ground wire into offset middle hole,
and mortise and AX/DPS wires into bottom hole, being careful not
to pinch wires (Fig. 12A).
2. Insert (2) #8-32 x 1-1/4" screws through inside escutcheon and
thread into outside escutcheon (Fig. 12B).
3. Straighten escutcheons and check that latch screws
are tightened securely.
Inside.of.Door
Fig...12A
Inside.of.Door
Latch Screws
Fig...12B
Ground
Ring
Terminal
Fig..11A
A7763B 17