Installation.wiring - Assa Abloy Sargent v.S1 Profile Installation Instructions Manual

Installation Wiring
6
A
PoE frame harness assembly (From McKinney)
B
PoE data hinge (Patent Pending) (From McKinney)
C
PoE door harness* (From McKinney)
Supplied.by.CI
B-Splice
.Crimp.Connector
RJ45-M
Ceiling
24AWG
Stranded
Wire for
Earth
Ground
inside
15' Frame
Harness
Frame-Side
Harness
Assembly
(15' length)
Cable
drain wire
concealed
Molex-M Molex-F
in shrink
tubing
A
4 A7763B
Certified Integrator (CI) supplies and terminates
the B-Splice connector and the
Male RJ45 connector from harness to
end user provided facility cable
Drain.Wire
RJ45-F Jack Cable: CAT 5e or higher
24 AWG shielded with drain wire
Cable
: CAT 5e,
26 AWG stranded,
shielded, 100ohm
Molex-F Molex-M
B C
Ring Terminal
Secured to Lock
Mounting Plate
Wiring.to.TIA-568-B.Standard
Profile Series v.S1 PoE Cylindrical Lock
D DPS: Door Position Switch (cylindrical and exits only)
E
Profile Series v.S1 PoE lock
* Order of installation may vary.
Refer to appropriate sections for instructions.
Patch Cable:
Patch Panel to
PoE Switch
E
PoE.
Lock
4-Pin
D
4-Pin
Ground
Supplied.by.End.User
PoE Switch
Patch Panel
Drain Wire Terminated on Rack
Approved.Software
Notes:
• Connectors go on only one
way. They cannot be placed
in an incorrect position.
• Do not force and do not
offset connectors.
• Be sure they are completely
seated (flush).
PoE Switch is
terminated to
Earth ground