Assa Abloy Sargent v.S1 Profile Installation Instructions Manual page 16

Step #9 – Escutcheon Wire Connections
Images are shown without gasket.
If gasket is necessary, refer to Step #5.
Before the controller is attached
to the door:
1. Attach the reader assembly
ribbon cable into the back of
the controller assembly
(side that faces towards
the door when mounted
(Fig. 9A).
2. Attach the antenna to the
circuit board in the plastic
housing under the
controller assembly.
Note: The difference between
the wiring for the iCLASS 13.35 MHz
reader and the 125 kHz Prox is that
the iCLASS wiring includes
an antenna wire.
3. Attach the ground wire to the
bottom of the controller
assembly (E1, Fig. 9A).
Step #10 – Additional Wiring Connections
Lock, DPS and raceway wire connections:
1. Connect the cable from the cylindrical
lock to the bottom of the controller
assembly (TB1, Fig. 10A).
2. Connect the AX/DPS connector
to the 2-pin harness.
3. Push the two connectors
from the raceway over the
controller assembly, through
the gap between the plastic
controller assembly and the
escutcheon, to the front
of the circuit board.
16 A7763B
Profile Series v.S1 PoE Cylindrical Lock
3
Ground
Wire
Reader
1
Cable
2 Antenna
(iCLASS only)
Outside.
Escutcheon
Outside. .
Escutcheon
Door Position
Switch (DPS)
Ground
Ring
Terminal
Reader
Ribbon
1
Cable
2
Antenna
(iCLASS only)
3
Ground
Wire
Inside.of.Door
Ground
3
Ring
Terminal
4-Pin
Connectors
From Hinge
TB1
1
Reader
Ribbon Cable
2
Ground Wire
AX/DPS
1
Lock
Inside.
Escutcheon..
(Back)
Fig..10A
Inside.of.Door
4-Pin Connectors
From Hinge
Inside.
Escutcheon..
(Back)
Fig...9A
Antenna
(iCLASS
only)
Unused
2