Profile Series v.S1 PoE Cylindrical Lock
Frame Harness Installation
A
Supplied.by.CI
B-Splice
.Crimp.Connector
RJ45-M
Ceiling
24AWG
Stranded
Wire for
Earth
Ground
inside
15' Frame
Harness
Frame-Side
Harness
Assembly
(15' length)
Cable
drain wire
concealed
in shrink
Molex-M
tubing
B
PoE Data Hinge
4-pin M
4-pin F
6-pin M
Frame
Cut.end./.ceiling-side.PoE.harness:.
Suggested installation of components and wire harness supplied by McKinney:
Do not confuse pair numbers with pin numbers. A pair number is used for
reference only (e.g.: 10Base-T Ethernet uses pairs 2 & 3). The pin numbers
indicate actual physical locations on the plug and jack.
Hinge.side.of.PoE.harness:
1. Feed cut end of harness into hole on hinge-side through single access hole.
2. Push one of the connectors back through hole and feed into separate
access hole.
Each of the hinge-side harness connectors should end up threaded through
a different access hole and matched to the same size pin connector from
the door harness:
•
4-pin male Molex connector.
•
6-pin male Molex connector with ground wire.
Drain.Wire
6-pin F
PoE.Hinge.(Patent.Pending)
TIA-568-B.Standard.Wiring
Pair Number
1
White/Blue
2
White/Orange
3
White/Green
4
White/Brown
Hinge-side harness connectors:
• 4-pin male molex connector
• 6-pin male molex connector with ground wire
Lock-side harness connectors:
• Ring terminal
• (2) 4-pin connectors
• 4-pin Molex connector
• 4-pin connector
Notes:
•
Connectors go on only one way. They cannot be
plugged to incorrect position.
•
Do not force and do not offset connectors.
•
Be sure they are completely seated (flush).
Wire
PIN
White/Blue
5
Blue
4
White/Orange
1
Orange
2
White/Green
3
Green
6
White/Brown
7
Brown
8
A7763B
5