Process Technology LUFRAN Instruction page 98

Spare Parts (Continued):
Additional Spare Parts for Specific Units:
Part for the
Process
Following
Technology
Wattage
Part #
**
**
TC-L-KT-15
TC-L-KT
(72kW, 208V)
Recommendations:
1) One complete spare parts kit is sufficient for every 4 to 6 Lufran fluoropolymer inline
water heaters installed in a single location. Be sure to immediately reorder any parts
that are used.
2) Sensors for the inlet/outlet process water (Part # TC-DI-L-2.25) are a required spare
part for each DI Heating Column.
Note: Quantities may vary depending on the number of heating columns in a particular
unit.
M-43-01
Revision - Date: 08 – 04/06/15
Units:
FUSE: high voltage power distribution
(Refer to page 1 of the electrical prints for the specific part
number of these fuses.)
HEATER: replacement heating column
(Refer to label on heating column for the specific model
number of this part)
65, 72, SENSOR: heating column water temperature, J-type
130, 144 thermocouple, one sensor per column
SENSOR: heating column water temperature, J-type
52, 105,
thermocouple, one sensor per column
Description
- 98 -
Qty
3
1
2
1
Lufran Single Outlet Manual