Positioning The Unit - Process Technology LUFRAN Instruction

Positioning the Unit:

1) Once the Lufran fluoropolymer inline water heater has been removed from the crate
and the unit passes the damage inspection, it can be moved to the service location.
Move the unit using either the lifting hooks located on top of the enclosure or by
lifting the unit from underneath using a fork truck or other suitable handling
equipment.
2) The unit was shipped with the leveling feet extended. To utilize the castors the
leveling feet must be retracted.
3) Place the unit on a hard, level surface.
4) Ensure the unit is secured so as not to roll as the casters are extended.
5) Leveling is accomplished by adjusting the stem and foot that is concentric with the
caster spindle.
M-43-01
Revision - Date: 08 – 04/06/15
The castors should not be used to move the
unit over long distances or on uneven surfaces.
They are
adjustments to the position of the unit at its
place of operation. Move the unit slowly, as
there is no means of slowing or stopping the
unit. Ensure that there are sufficient personnel
to move the unit safely. Failure to follow these
instructions can result in serious personal
injury and/or damage to the unit.
Figure 7: Leveling Foot Located on Castor
Ensure the unit is on a smooth, level surface
and there are sufficient personnel to hold the
unit in place. As the leveling feet are retracted
and the unit rests on the castors unexpected
movement may result. Failure to properly
secure the unit may result in serious personal
injury and/or damage to equipment.
- 19 -
intended to facilitate
Lufran Single Outlet Manual
small