Updating Software - Planmeca ProOne Technical Manual

UPDATING SOFTWARE

3 UPDATING SOFTWARE
Switch the X-ray unit off. The on/off switch is located on the back of the moving column.
Insert the USB memory stick containing the new software into the USB port on the back of
the moving column. To do this, you will first have to remove the cover that protects the
terminals. Remove the protective cover by unscrewing the two screws at the bottom and
then unlatching the cover at the top.
NOTE Do not plug any other USB devices into the USB port.
Back of
moving column
Figure 82
You can now switch the X-ray unit back on.
Technical Manual
USB port
Screws that hold the protective cover in position
CHAPTER D
MOVING COLUMN
Planmeca ProOne D-15