Planmeca ProOne Technical Manual page 4

TABLE OF CONTENTS
Chapter D
Chapter E DIAGRAMS
The manufacturer, assembler, and importer are responsible for the safety, reliability and
performance of the unit only if:
- installation, calibration, modification and repairs are carried out by qualified author-
ized personnel
- electrical installations are carried out according to the appropriate requirements such
as IEC364
- equipment is used according to the operating instructions
Planmeca pursues a policy of continual product development. Although every effort is
made to produce up-to-date product documentation this publication should not be re-
garded as an infallible guide to current specifications. We reserve the right to make
changes without prior notice.
COPYRIGHT PLANMECA 2007-10
PUBLICATION PART NUMBER 10016258 Revision 1
TOC - ii Planmeca ProOne
3 PARTS REPLACEMENT ........................................................................... C-33
3.1 Replacing the sensor head .......................................................................C-33
3.2 Replacing the tube head/PSU...................................................................C-35
3.3 Replacing the primary collimator...............................................................C-37
3.4 Replacing the layer light............................................................................C-38
3.5 Replacing the midsagittal plane positioning light ......................................C-39
MOVING COLUMN
1 REMOVING COVERS ...............................................................................D-1
1.1 Opening the front panel ..............................................................................D-1
2 PARTS REPLACEMENT ..............................................................................D-2
2.1 Replacing the Frankfort plane positioning light ...........................................D-2
2.2 Replacing the control panel ........................................................................D-3
2.3 Replacing the CPU PCB .............................................................................D-4
2.4 Replacing the lift motor ...............................................................................D-5
2.5 Replacing the lift motor steel cables .........................................................D-10
3 UPDATING SOFTWARE...........................................................................D-15
Technical Manual