Parts Replacement; Replacing The Frankfort Plane Positioning Light - Planmeca ProOne Technical Manual

CHAPTER D
MOVING COLUMN
2

PARTS REPLACEMENT

2.1

Replacing the Frankfort plane positioning light

Open the front panel of the moving column as described in section 1.1 "Opening the front
panel" on page D-1.
Disconnect the light cable by carefully pulling it out of the connector socket. Then unscrew
the screw that holds the light in position.
Disconnect the cable
Unscrew
the screw
Frankfort
plane
positioning light
Figure 62
Install the new light in reverse order. Adjust the new light as described in section 2.8.3
"Adjusting the Frankfort plane light position" on page C-24.
D-2 Planmeca ProOne
PARTS REPLACEMENT
Technical Manual