Replacing The Midsagittal Plane Positioning Light - Planmeca ProOne Technical Manual

PARTS REPLACEMENT
3.5

Replacing the midsagittal plane positioning light

Remove the sensor head cover, tube head cover and C-arm cover as described in section
1 "REMOVING COVERS" on page C-1.
Disconnect the light cable by carefully pulling it out of the connector socket. Using the tip
of a small screwdriver might make it easier to detach the connector from the socket. Then
unscrew the two attachment screws that hold the light assembly in position.
C-arm top frame
Figure 60
Install the new light in reverse order. Adjust the new light as described in section 2.8 "Step
5: Adjusting the positioning lights" on page C-20.
Technical Manual
Disconnect the cable
Unscrew two screws
Midsagittal plane
positioning light
CHAPTER C
C-ARM AND UPPER ARM
Planmeca ProOne C-39