Installing The Wheels; Installing The Steering Wheel - Toro Reelmaster 3100-D Series Operator's Manual

Media and Additional Parts
Description
Ignition key
Operator's Manual
Engine operator's manual
Operator training material
Pre-delivery checklist
Certificate of compliance
Note:
Determine the left and right sides of the
machine from the normal operating position.
1

Installing the Wheels

Parts needed for this procedure:
2 Front wheel assemblies
1 Rear wheel assembly
Procedure
1. Mount a wheel assembly onto each wheel hub
(valve stem outward).
Important:
The rear tire has a narrower rim
than the front tires.
2. Install lug nuts and torque to 61 to 88 N∙m (45
to 65 ft-lb).
Qty.
2 Start the engine.
1
Read before operating the machine.
1
1 View before operating the machine.
Check to ensure that the machine has been properly set
1
up.
1 Ensure CE compliance.
2
Installing the Steering
Wheel
Parts needed for this procedure:
1 Steering wheel
1 Steering-wheel cap
1 Large washer
1 Jam nut
1 Screw
Procedure
1. Slide the steering wheel onto the steering shaft
(Figure
1. Steering wheel
2. Washer
2. Slide the washer onto the steering shaft
3).
12
Use
3).
Figure 3
3. Jam nut
4. Cap
g010834
(Figure