Installing The Carrier Frames To The Cutting Units - Toro Reelmaster 3100-D Series Operator's Manual

1. Lift arm, right
2. Retaining ring
3. Lift arm, left
5. Remove the rear retaining rings securing the
mounting pins to each end of the lift cylinder.
6. Secure the right end of the lift cylinder to the
right lift arm with a pin and 2 spacers
15). Secure it with a retaining ring.
7. Secure the left end of the lift cylinder to the left
lift arm with a pin. Secure it with a retaining ring.
10
Installing the Carrier
Frames to the Cutting Units
No Parts Required
Procedure
1. Remove the cutting units from the cartons.
Adjust them as described in the cutting unit
operator's manual.
2. Position a front carrier frame
each front cutting unit.
Figure 15
4. Lift cylinder
5. Spacers (2)
6. Mounting pin
(Figure
(Figure 16) onto
g011966
1. Front carrier frame
3. Secure the mounting links to the front carrier
frames as follows:
•
Secure the front mounting links to the middle
carrier frame holes with a bolt (3/8 x 2-1/4
inch), 2 flat washers, and a locknut, as
shown in
each side of the link when mounting. Torque
the fasteners to 42 N∙m (31 ft-lb).
•
Secure the rear mounting links to the middle
carrier frame holes with a bolt (3/8 x 2-1/4
inch), 2 flat washers, and a locknut, as
shown in
each side of the link when mounting. Torque
the fasteners to 42 N∙m (31 ft-lb).
1. Front carrier frame
2. Front mounting link
3. Rear mounting link
18
Figure 16
Figure 17. Position a washer on
Figure 17. Position a washer on
Figure 17
g011968
g012688