Changing The Engine Oil And The Filter - Toro Reelmaster 3100-D Series Operator's Manual

4. Remove and replace the primary filter
62).
Note:
Cleaning the used element may damage
the filter media.
Figure 62
1. Primary filter
5. Inspect the new filter for shipping damage and
check the sealing end of the filter and the body.
Do not use a damaged element.
6. Insert the new filter by applying pressure to the
outer rim of the element to seat it in the canister.
Do not apply pressure to the flexible center
of the filter.
7. Clean the dirt ejection port located in the
removable cover.
8. Remove the rubber outlet valve from the cover,
clean the cavity, and replace the outlet valve.
9. Install the cover orienting the rubber outlet valve
in a downward position—between approximately
5 o'clock to 7 o'clock when viewed from the end.
10. Secure the cover latches.
Changing the Engine Oil
and the Filter
Service Interval: After the first 50 hours
Every 150 hours
1. Remove either drain plug
the oil flow into a drain pan; when the oil stops
flowing, install the drain plug.
(Figure
g008910
(Figure 63) and let
1. Drain plugs
2. Remove the oil filter
1. Oil filter
3. Apply a light coat of clean oil to the new filter
seal and install the oil filter.
Note:
Do not overtighten the filter.
4. Add oil to the crankcase; refer to
Engine-Oil Level (page
48
Figure 63
(Figure 64).
Figure 64
Checking the
26).
g008911
g008912