Toro Reelmaster 3100-D Series Operator's Manual page 6

99-3444
1. Transport speed—fast
110–0806
117-3270
1. Warning—do not touch the hot surface.
2. Cutting/dismemberment hazard, hand; entanglement
hazard, belt—stay away from moving parts, keep all guards
and shields in place.
decal99-3444
2. Mowing speed—slow
decal110-0806
decal117-3270
Note:
This machine complies with the industry standard
stability test in the static lateral and longitudinal tests with the
maximum recommended slope indicated on the decal. Review the
instructions for operating the machine on slopes in the Operator's
Manual as well as the conditions in which you would operate
the machine to determine whether you can operate the machine
in those conditions on that day and at that site. Changes in the
terrain can result in a change in slope operation for the machine.
If possible, keep the cutting units lowered to the ground while
operating the machine on slopes. Raising the cutting units while
operating on slopes can cause the machine to become unstable.
1. Tipping hazard—do not drive across slopes greater than
17 degrees.
Note:
This machine complies with the industry standard
stability test in the static lateral and longitudinal tests with the
maximum recommended slope indicated on the decal. Review the
instructions for operating the machine on slopes in the Operator's
Manual as well as the conditions in which you would operate
the machine to determine whether you can operate the machine
in those conditions on that day and at that site. Changes in the
terrain can result in a change in slope operation for the machine.
If possible, keep the cutting units lowered to the ground while
operating the machine on slopes. Raising the cutting units while
operating on slopes can cause the machine to become unstable.
1. Tipping hazard—do not drive across slopes greater than
25 degrees.
6
121-3598
CE only
121-3628
Non-CE only
133-8062
decal121-3598
decal121-3628
decal133-8062