Installing The Exhaust Guard (Ce Only); Installing The Roll Bar - Toro 03170 Operator's Manual

6
Installing the Exhaust Guard
(CE Only)
Parts needed for this procedure:
1 Exhaust guard
4 Self-tapping screw
Procedure
1. Position the exhaust guard around the muffler while
aligning the mounting holes with the holes in the
frame (Figure 11).
1. Exhaust guard
2. Secure the exhaust guard to the frame with 4
self-tapping screws (Figure 11).
Figure 11
7

Installing the Roll Bar

Parts needed for this procedure:
1 Roll bar assembly
4 Flange head bolts
4 Locknuts
1 Hose clamp
Procedure
Important: Never weld or modify a rollover
protection system (ROPS). Replace a damaged
ROPS, do not repair or revise. Any alteration of a
ROPS must be approved by the manufacturer.
1. Lower the roll bar onto the traction unit mounting
brackets, aligning the mounting holes. Ensure that
the vent tube on the roll bar is on the left side of
the machine (Figure 12).
1. ROPS
2. Mounting bracket
3. Vent tube
2. Secure each side of the roll bar to the mounting
brackets with 2 flange head bolts and locknuts
(Figure 12). Torque the fasteners to 60 ft-lb (81
N-m).
3. Secure the fuel line vent hose to the vent tube on the
roll bar with the hose clamp.
CAUTION
You must connect the fuel line vent hose to the
vent tube prior to starting the engine or fuel will
flow from the hose.
18
Figure 12
4. Fuel line vent tube hose
5. Hose clamp