5
Installing the CE Decal
Parts needed for this procedure:
1
Warning decal (121-3598)
Procedure
If this machine will be used for CE, affix the CE decal
over the corresponding non-CE decal.
6
Installing the Hood Latch
(CE Only)
Parts needed for this procedure:
1
Lock bracket
2
Rivet
1
Washer
1
Screw (1/4 x 2 inches)
1
Locknut (1/4 inch)
Procedure
1.
Unhook the hood latch from the hood-latch
bracket.
2.
Remove the rivets (2) securing the hood-latch
bracket to the hood
hood-latch bracket from the hood.
(Figure
7). Remove the
1. Hood-latch bracket
3.
While aligning the mounting holes, position the
CE lock bracket and the hood-latch bracket onto
the hood. The lock bracket must be against the
hood
(Figure
8). Do not remove the bolt and nut
assembly from the lock bracket arm.
1. CE lock bracket
4.
Align the washers with the holes on the inside of
the hood.
5.
Rivet the brackets and the washers to the hood
(Figure
8).
6.
Hook the latch onto the hood-latch bracket
(Figure
9).
15
Figure 7
2. Rivets
Figure 8
2. Bolt and nut assembly
g012628
g012629