Checking The Angle Indicator - Toro Reelmaster 3100-D Series Operator's Manual

WARNING
Incorrect battery cable routing could
damage the tractor and cables causing
sparks. Sparks can cause the battery
gasses to explode, resulting in personal
injury.
• Always disconnect the negative
(black) battery cable before
disconnecting the positive (red)
cable.
• Always connect the positive (red)
battery cable before connecting the
negative (black) cable.
1. Positive (+) battery cable
Important:
If the battery is ever removed,
make sure that the battery clamp bolts are
installed with the bolt heads positioned on
the bottom side and the nuts on the top
side. If the clamp bolts are reversed, they
may interfere with the hydraulic tubes when
shifting the cutting units.
9. Coat both battery connections with Grafo 112X
(skin over) grease, Toro Part No. 505-47,
petroleum jelly, or light grease to prevent
corrosion.
10. Slide the rubber boot over the positive terminal
to prevent a possible short from occurring.
11. Install the battery cover.
Figure 5
2. Negative (–) battery cable
4
Checking the Angle
Indicator
Parts needed for this procedure:
1 Inclinometer
Procedure
DANGER
To reduce risk of injury or death due to
rollover, do not operate the machine on side
hills steeper than 25º.
1. Park the machine on a flat, level surface.
2. Verify that the machine is level by placing a hand
held inclinometer (supplied with the machine)
on the frame cross rail, by the fuel tank
6). The inclinometer should read zero degrees
when viewed from the operator's position.
g011213
1. Angle indicator
3. If the inclinometer does not read zero degrees,
move the machine to a location where a zero
degree reading is obtained. The angle indicator,
mounted on the machine, should now read zero
degrees as well.
4. If the angle indicator does not read zero degrees,
loosen the 2 screws and nuts securing the angle
indicator to the mounting bracket, adjust the
indicator to obtain a zero degree reading, and
tighten the bolts.
14
Figure 6
(Figure
g008873