Table of Contents
Advertisement
8. Mount the seat straps to the frame with the fasteners
and spacers removed in step 1.
9. Slide the seat completely forward and backward to
ensure proper operation and that the seat switch wires
and connectors are not pinched or do no contact any
moving parts.
Checking the Angle Indicator
Danger
To reduce risk of injury or death due to rollover,
do not operate the machine on side hills steeper
than 255.
1. Park the machine on a flat, level surface.
2. Verify that the machine is level by placing a hand held
inclinometer (supplied with the machine) on the frame
cross rail, by the fuel tank (Fig. 7). The inclinometer
should read zero degrees when viewed from the
operator's position.
1
Figure 7
1. Angle indicator
3. If the inclinometer does not read zero degrees, move the
machine to a location where a zero degree reading is
obtained. The angle indicator, mounted on the machine,
should now read zero degrees as well.
4. If the angle indicator does not read zero degrees, loosen
the two screws and nuts securing the angle indicator to
the mounting bracket, adjust the indicator to obtain a
zero degree reading, and tighten the capscrews.
Installing the Hood Latch (CE)
1. Unhook the hood latch from the hood latch bracket
(Fig. 8).
2. Slide the hood lock bracket onto the latch (Fig. 8).
3. Hook the latch onto the hood latch bracket (Fig. 8).
4. Insert a bolt (1/4 x 1-1/2 in.) through the hood lock
bracket and secure it with a flat washer and locknut
(Fig. 8).
2
3
1. Hood latch
2. Hood latch bracket
Installing the Exhaust Guard
(CE)
1. Position the exhaust guard around the muffler while
aligning the mounting holes with the holes in the frame
(Fig. 9).
2. Secure the exhaust guard to the frame with 4
self-tapping screws (Fig. 9).
1. Exhaust guard
15
Figure 8
3. Hood lock bracket
1
Figure 9
1
Advertisement
Table of Contents
