Changing The Hydraulic Filter - Toro Reelmaster 3100-D Series Operator's Manual

Figure 74
1. Hydraulic filter
3. Install the hydraulic line when hydraulic fluid
stops draining.
4. Fill the reservoir (Figure
13.2 L (3.5 US gallons) of hydraulic fluid; refer to
Checking the Hydraulic System (page
Important:
Use only the hydraulic fluids
specified. Other fluids could damage the
hydraulic system.
Figure 75
1. Hydraulic fill cap
5. Install the reservoir cap, start the engine, and
use all of the hydraulic controls to distribute the
hydraulic fluid throughout the system.
6. Check for leaks; then shut off the engine.
7. Check the fluid level and add enough to raise
the level to Full mark on the dipstick. Do not
overfill.
g190871
75) with approximately
28).
g008886
Changing the Hydraulic
Filter
Service Interval: After the first 10 hours
Every 200 hours/Yearly (whichever comes first)
Use a genuine Toro replacement filter (Part No.
54-0110).
Important:
Using any other filter may void the
warranty on some components.
1. Park the machine on a level surface, lower the
cutting units, shut off the engine, engage the
parking brake, and remove the key from the
ignition switch.
2. Pinch off the hose to the filter mounting plate.
3. Clean around the filter mounting area.
4. Place a drain pan under the filter
and remove the filter.
5. Lubricate the new filter gasket and fill the filter
with hydraulic fluid.
6. Ensure that the filter mounting area is clean,
screw the filter on until the gasket contacts the
mounting plate, and then tighten the filter 1/2
turn.
7. Release the hose to the filter mounting plate.
8. Start the engine and let it run for about 2 minutes
to purge the air from the system.
9. Shut off the engine and check for leaks.
55
(Figure 74)