Adjusting The Lift Arms - Toro Reelmaster 3100-D Series Operator's Manual

1. O-ring
6. Mount the motor to the drive end of the cutting
unit, and secure it with 2 cap screws provided
with cutting unit
13

Adjusting the Lift Arms

No Parts Required
Procedure
1. Start the engine, raise the lift arms, and check to
ensure that the clearance between each lift arm
and the floor plate bracket is 5 to 8 mm (0.18 to
0.32 inches) (Figure
Cutting units removed for clarity
1. Lift arm
2. Floor plate bracket
Figure 24
2. Reel motor
(Figure 24).
25).
Figure 25
3. Clearance
Note:
If the clearance is not in this range, adjust
the cylinder as follows:
A. Back off the stop bolts and adjust the
cylinder to attain the clearance
g012025
1. Stop bolt
2. Lift arm
B. Back off the jam nut on the cylinder
27).
1. Front cylinder
C. Remove the pin from the rod end and rotate
the clevis.
D. Install the pin and check the clearance.
E. Repeat steps
F. Tighten the clevis jam nut.
Note:
If the rear lift arm clunks during transport,
reduce the clearance.
2. Check to ensure that the clearance between
each lift arm and stop bolt is 0.13 to 1.02 mm
(0.005 to 0.040 inches)
Note:
If the clearance is not in this range, adjust
g008876
the stop bolts to attain clearance.
3. Start the engine, raise the lift arms, and check
to ensure that the clearance between the wear
strap on the top of the rear cutting unit wear bar
and the bumper strap is 0.51 to 2.54 mm (0.02
to 0.10 inches) as shown in
21
(Figure
Figure 26
3. Clearance
Figure 27
2. Jam nut
A through D if necessary.
(Figure 26).
Figure 28.
26).
g008877
(Figure
g008878