Toro Reelmaster 3100-D Series Operator's Manual page 39

Important:
After washing the machine, move the
Sidewinder mechanism from left to right several
times to remove the water between the bearing
blocks and the cross tube (Model 03171 only).
Selecting the Clip Rate (Reel
Speed)
To achieve a consistent, high quality of cut and a
uniform after-cut appearance, it is important that the
reel speed be matched to the height of cut.
Important:
If the reel speed is too slow, you may
notice visible clip marks. If the reel speed is too
fast, the cut may have a fuzzy appearance.
Adjust the clip rate (reel speed) as follows:
1. Verify the height-of-cut setting on the cutting
units. Use the column of the chart listing
either 5 or 8 reels, and find the height-of-cut
listing nearest the actual height-of-cut setting.
Look across the chart to find the number that
corresponds to that height of cut.
39