Troubleshooting - Wacker Neuson RT82-SC3 Operator's Manual

RT / RTx

10 Troubleshooting

Problem Reason
Engine does Fuel tank empty
not start
Wrong type of fuel
Water in fuel
Old fuel
Fuel system not primed
Fuel filter restricted or clogged
Battery connections loose or corroded
Discharged battery
Engine oil level too low
Air cleaner element clogged
Faulty starter motor
Faulty starter button on control box or
transmitter
Inoperative fuel valve solenoids on
engine (Kohler powered machines
only)
Inoperative stop solenoid on engine
(Kubota powered machines only)
Inoperative starter relay
Electrical connections loose or broken
Machine out of infra-red signal range
Transmitter and decoder channels are
different
Communication fault
Engine starts, Fuel tank empty
then stops
Fuel filter restricted or clogged
Fuel lines broken or loose
Machine out of infra-red range.
Transmitter automatically powered off
due to inactivity
wc_tx003864gb_FM10.fm
Remedy
Fill with No. 2 diesel fuel and prime fuel lines.
Drain tank, change fuel filter, and fill with fresh
fuel.
Drain water from fuel filter.
Drain tank, change fuel filter, and fill with fresh
fuel.
Prime fuel system.
Replace fuel filter.
Check connections. Tighten or clean as needed.
Charge or replace battery.
Add engine oil.
Maintain air cleaner.
Repair or replace.
Repair or replace.
Repair or replace.
Repair or replace.
Repair or replace.
Check connections; repair or replace.
Move transmitter closer to machine.
Set transmitter and decoder to the same channel.
See topic Communication Faults.
Fill with No. 2 diesel fuel and prime fuel lines.
Replace fuel filter.
Check fuel lines; tighten, repair or replace as
needed
Move transmitter closer to machine.
Turn on transmitter.
115
Troubleshooting