Malfunctions; Troubleshooting Machine - Wacker Neuson AP1840 Operator's Manual

Vibration plate
Hide thumbs Also See for AP1840:
Table of Contents

Advertisement

Malfunctions

13.1 Troubleshooting machine

13
Malfunctions
13.1
Troubleshooting machine
Fault
The machine will not operate.
The machine is displaying unex-
pected faults when putting into oper-
ation or operation.
The machine switches itself off.
* Have this work carried out by a service partner.
50
WARNING
Danger to life due to unauthorized troubleshooting!
► If faults occur on this machine which are not described in these oper-
ating instructions, contact the manufacturer.
► Do not rectify faults on your own.
NOTICE
Possible error message on the rechargeable battery
If the machine is started too quickly, error messages may appear on the
accumulator.
► Wait at least 4 seconds after activating the rechargeable battery.
► Then continue with the starting procedure.
Possible cause
On/Off switch is not off.
Rechargeable battery is not acti-
vated.
The charge condition of the
rechargeable battery is too low.
The rechargeable battery is not in-
serted correctly into the machine.
The rechargeable battery is defec-
tive.
Troubleshooting Observe recharge-
able battery.
The charge condition of the
rechargeable battery is too low.
The machine was overloaded.
Machine is overheated.
Machine under temperature.
Remedy
Move the switch to position 0.
Activate rechargeable battery.
Charge the rechargeable battery.
Insert the rechargeable battery cor-
rectly into the machine.
Have the rechargeable battery re-
paired.*
Deactivate the rechargeable battery
and remove it from the machine. If
the fault persists, have the
rechargeable battery repaired.*
Charge the rechargeable battery.
Switch the machine on again.
Let the machine cool down.
Operate the machine only within the
permissible temperature range,
Technical Data.
Operator's manual | AP | 5100060708 | 12/2020 | [us]

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ap1850

Table of Contents