11 Troubleshooting; Fault Table - Wacker Neuson BS Operator's Manual

Vibratory rammer
Table of Contents

Advertisement

11 Troubleshooting

DANGER
Danger to life from unauthorized troubleshooting.
11.1

Fault table

Fault
The engine does not start.
The engine shuts down shortly after
starting.
The engine does not have any
power.
The engine revs up, but the
ramming system has no power.
Recoil starter defective.
*
Contact your Wacker Neuson contact partner.
100_0201_ts_0001.fm
If faults occur with this machine that are not described in this manual, contact the
manufacturer. Do not eliminate the faults independently.
Cause
Fuel cock is not closed.
Fuel tank is empty.
Fuel line is clogged.
The fuel filter is clogged.
The carburetor is clogged.
The air filter is clogged.
The spark plug cap is defective.
The spark plug is defective.
The spark plug is loose.
The spark plug air gap of the spark
plug has been incorrectly set.
Fuel tank is empty.
The fuel filter is clogged.
Air filter is dirty.
Air filter is dirty.
Defective centrifugal clutch.
The starter rope is stuck.
The starter rope is torn.
11 Troubleshooting
Remedial measure
Open fuel cock.
Top off the fuel.
Have the fuel line cleaned.*
Have the fuel filter replaced.*
Have the carburetor cleaned.*
Clean air filter.
Have the machine repaired.*
Replace the spark plug.
Tighten the spark plug.
Adjust the spark plug air gap.
Top off the fuel.
Have the fuel filter replaced.*
Clean or replace air cleaner.
Clean or replace air cleaner.
Have the centrifugal clutch
replaced.*
Have the starter rope replaced.*
27

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bs30

Table of Contents