Hydraulic Oil Safety; Safety Guidelines For Lifting The Machine - Wacker Neuson RT82-SC3 Operator's Manual

Safety Information
1.6

Hydraulic Oil Safety

WARNING
Possibility of severe injury. Hydraulic oil is under high pressure and becomes very
hot during operation.
► To avoid injury, obey the safety instructions listed below.
Safety ■ Inspect the hydraulic system thoroughly before operating the machine.
instructions
■ Do not touch hydraulic oil or hydraulic components while the machine is
operating. Wait until the machine is cool.
■ Before disconnecting hydraulic fittings or hoses, ensure that all pressure has
been bled from the circuit. Set all controls in neutral, turn the engine off, and
allow the fluids to cool before loosening hydraulic fittings or attaching test
gauges.
■ Hydraulic oil escaping under high pressure may penetrate the skin, causing
burns, blindness, or other serious injuries or infections. Contact a physician
immediately for treatment if your skin has been penetrated by hydraulic oil, even
if the wound seems minor.
■ Fluid leaks from small holes are often practically invisible. Do not use your bare
hands to check for leaks. Check for leaks using a piece of cardboard or wood.
■ Hydraulic oil is extremely flammable. Stop the engine immediately if a hydraulic
leak is detected.
■ After servicing the hydraulics, make sure all components are reconnected to the
proper fittings. Failure to do so may result in damage to the machine and/or
injury to a person on or near the machine.
1.7

Safety Guidelines for Lifting the Machine

When lifting the machine:
■ Make sure slings, chains, hooks, ramps, jacks, forklifts, cranes, hoists, and any
other type of lifting device used is attached securely and has enough weight-
bearing capacity to lift or hold the machine safely. See the Technical Data
chapter for machine weight.
■ Remain aware of the location of other people when lifting the machine.
■ Only use the lifting points and tie-downs described in the Operator's Manual.
■ Make sure the transporting vehicle has sufficient load capacity and platform size
to safely transport the machine.
To reduce the possibility of injury:
■ Do not stand under the machine while it is being lifted or moved.
■ Do not get onto the machine while it is being lifted or moved.
24
RT / RTx
wc_si000902gb_FM10.fm