Troubleshooting - Wacker Neuson MP70 Operator's Manual

Vibroplate
Table of Contents

Advertisement

MP70
6

Troubleshooting

Problem
Plate does not
develop full speed.
Poor compaction.
Engine running, no
vibration.
Plate jumps or
compacts unevenly.
wpm_tx003788gb.fm
Cause
Engine throttle control not
completely open.
Throttle control not adjusted
correctly.
Ground too wet, plate sticking.
Drive belt loose or worn, slip-
ping on pulleys.
Exciter bearings binding.
Air filter clogged with dust,
reducing engine performance.
Engine speed is too low.
Engine throttle not open.
Drive belt loose or broken.
Clutch damaged.
Engine speed is too low.
Too much oil in exciter
Ground surface too hard.
Shockmounts loose or
damaged
Remedy
Allow soil to dry before
compacting.
Adjust or replace belt.
Check that engine mounting
bolts are tight.
Check condition and level of oil
in exciter.
Check engine speed with
tachometer.
Adjust or repair engine to run
correctly speed. Refer to
engine manual.
Adjust or replace the drive belt.
Inspect and replace the clutch.
Check engine speed.
Adjust oit to correct level.
Inspect and replace the
shockmounts.
29
Troubleshooting

Advertisement

Table of Contents
loading

Table of Contents