Photocell Verification - Bravo 8105 Installation Manual

B R A V O ™ 8 1 0 5 M A C H I N E I N S T A L L A T I O N
2

Photocell Verification

Photocell Verification
Introduction
Procedure
Photograph
Procedure (Continued)
2-64
Verify that the standard Incoming Photocell functions properly. It is necessary to
have the computer On and a Process Screen displayed to test the Photocell.
Ensure that the incoming photocell is operating correctly.
Block the end of the photocell closest to the conveyor with a hand or a solid
object. Refer to Figure 2–32.
Figure 2–32
The Photocell Icon appears Red on the Process Graphic Screen. Refer to
Figure 2–33. The Photocell itself illuminates Red at the top of the device. Refer to
Figure 2–32. If the Conveyor is On, the Boards In Machine value under the PCBs
Data increments by one (1).
To clear the PCBs in Machine, select Maintenance > Clear All PCBs from the
Menu Bar at the top of the display.
Bravo™ 8105 Installation Guide
Place Solid Object
Beneath Photocell
Rev. 2