Verification Of Options In Software - Bravo 8105 Installation Manual

Verification of Options in Software

Introduction
Powering Up the Bravo
Photograph
After Power is Applied
Security Access
2-9317-370-00-0
The software is configured at the factory according to the options present on the
machine. Verify that the software is configured with the Options present on the
machine.
Turn the Bravo™ System On at the Main Power Disconnect Switch by placing the
switch in the On (1) position. Refer to Figure 2–23.The Main Power Disconnect
Switch is located on the lower Unload End of the Bravo™.
Figure 2–23
The machine turns On. The computer turns On. The Bravo™ System Software
opens. Selecting either the Graphic button (also Function Key F9) or the Tabular
button (also Function Key F8) at the top of the screen opens a Process Screen.
The Process Screen opens at the default Security level. To operate the machine it
is necessary to have the applicable fields selected in the Security Access Screen.
There are five (5) levels of security access available with the Bravo™ System. To
access Maintenance and Operation Functions it is necessary to have the
appropriate Security Level active. During installation, setting the Security Level to
Administrator level allows access to all functions as well as configuration of the
other five (5) Security Levels.
Bravo™ 8105 Installation Guide
B R A V O ™ 8 1 0 5 M A C H I N E I N S T A L L A T I O N
Verification of Options in Software
ON
2-51