Electrical Hazards - Bravo 8105 Installation Manual

Electrical Hazards

Introduction
Safety
Photograph
2-9317-370-00-0
Installation of this equipment involves exposure to situations which may result in
electrical shock if procedures are not properly followed. Pay close attention to
warnings of this nature throughout the context of this Guide.
Electrical work should only be performed by a qualified electrician.
Prior to applying power for the first time, ensure that the system is properly
grounded.
The power panels and terminal blocks of the reflow system present an electrical
hazard. High voltages are present on various parts of the system.
To ensure personal safety and avoid equipment damage, observe the following:
Electrical Hazard
Installation of this equipment involves exposure to High Voltage. High Voltage
can shock, burn, or cause death. Use extreme caution when performing voltage
and amperage tests on live voltage. These procedures must be performed only by
an authorized electrician, electrical engineer, or service technician familiar with
testing live voltage.
Electrical Hazard
When performing tests using AMP meters, volt meters, or ohm meters, electrical
shock hazard is present. These procedures must be performed only by an
authorized electrician, electrical engineer, or service technician familiar with
testing live voltage.
The following Photograph shows the electrical hazard warning tag:
Figure 1–2
Bravo™ 8105 Installation Guide
S A F E T Y I N F O R M A T I O N
Electrical Hazards
1-5