Dc Power Connections - Dell EMC PowerSwitch S4100-ON Series Installation Manual

1 Align the system with the rails, and slide the system into the rack.
2 Tighten the screws on each side of the switch front panel. See items 1 and 2 in the following illustration:
To remove the system from the rack, loosen the screws and slide the system out of the rack.

DC power connections

NOTE: Use the following instructions for all S5200F-ON Series switches except for the S5212F-ON switch. To connect DC
power to the S5212F-ON switch, see
Each DC powered system comes with a set containing a prewired (3-inch 8AWG) power supply connector and a four-screw wiring block,
as shown. One set is provided for each DC PSU.
S5212F-ON only DC power connections.
S5200F-ON Series switch installation 43