Connecting A N2200 Switch To A Power Source - Dell EMC Networking N Series Getting Started Manual

3 Connect the RJ-45 connector on the cable directly to the switch console
port. The Dell Networking console port is located on the right side of the
front panel and is labeled with a |O|O| symbol, as shown in Figure 1-8 on
page 20.
NOTE:
serial port via the local CLI. Only one serial console session at a time is
supported.
Figure 1-8. N2200 Front Panel with Console Port

Connecting a N2200 Switch to a Power Source

CAUTION:
manual as well as the safety information for other switches that connect to or
support the switch.
All N2200 models have one internal power supply. The power receptacles are
on the back panel.
AC and DC Power Connection
1 Make sure that the switch console port is connected to a VT100 terminal
or VT100 terminal emulator via the RJ-45 to DB-9 female cable.
2 Using a 5-foot (1.5 m) standard power cable with safety ground connected,
connect the power cable to the AC main receptacle located on the back
panel (see Figure 1-9 on page 21).
3 Connect the power cable to a grounded AC outlet.
20
Serial console access to the stack manager is available from any
Read the safety information in the Safety and Regulatory Information
Console Port