Table of Contents
Advertisement
20.1. VALIDATING STATUS OF A COMPONENT
When using your add-on, you can validate at any time, the status of any of the following components:
•
Air damper
•
Temperature probe (RTD)
•
Hot water system
20.2. AIR DAMPER AND HOT WATER
To check the status of the air damper or hot water, go to the main menu under "TROUBLESHOOT LINK" then go to
page 3. When the add-on is in wood heating, the damper is open. The green square next to "DAMPER" should be on
the left, (closed circuit). When another heating mode is on, the damper is closed, so the circuit is open and the green
square is on the right. Same logic goes for the hot water.
20.3. TEMPERATURE PROBE (RTD)
The temperature probe continuously reads the temperature in the plenum and displays it on the main page in the upper
right corner. If the probe fails, the error message "PLENUM OVERTEMP" will appear. See section 20.4 - MAIN
ERROR CODES, POSSIBLE CAUSES AND SOLUTIONS for more information.
20.4. MAIN ERROR CODES, POSSIBLE CAUSES AND SOLUTIONS
This section contains main error codes, possible causes and many suggestions to guide you in resolving them. To go
back to the main menu, press the
NOTE: IF, AFTER PERFORMING ALL THE POSSIBLE SOLUTIONS MENTIONED IN THE FOLLOWING SECTION,
YOU ARE STILL EXPERIENCING PROBLEMS WITH YOUR ADD-ON, CALL YOUR LOCAL DEALER OR AFTER-
SALE SERVICE.
NOTE: IF YOU NEED TO CONTACT YOUR DEALER OR TECHNICAL SUPPORT, MAKE SURE TO HAVE THE
MODEL OF YOUR ADD-ON AND THE SERIAL NUMBER ON HAND. (THEY CAN BE FOUND ON THE
CERTIFICATION LABEL ON THE SIDE OF THE ADD-ON).
42
COMBUSTION FAN FUSE
THE COMBUSTION FAN
FUSE BLEW UP
RESET
DETAILS
button.
Advertisement
Table of Contents
