Advertisement
The IR interface supports the wireless infrared transmitting and
receiving module. You must configure the setting through BIOS setup.
The CompactPCI connectors are firm and rigid, and require careful
handling while plugging and unplugging. Improper installation of a
card can easily damage the backplane of the chassis.
The insert/eject handles of MIC-3355 help you to install and remove
the card easily and safely. Follow the procedure below to install the
MIC-3355 into a chassis:
1. Hold the MIC-3355 vertically. Be sure that the card is pointing in
the correct direction. The components of the card should be
pointing to the right-hand side.
2. Holding both handles, pull out the red portion in the middle of the
handle to unlock it.
3. Insert the card into the chassis by sliding the upper and lower edges
of the card into the card guide.
4. Push the card into the slot gently by sliding the card along the card
guide until the handles meet the rectangular holes of the cross rails.
5. Pull the upper handle down and lift the lower handle up to push the
card into place.
Advertisement
